Hardware Manuals


Akiyama - Pulsar  

FRONT & REAR PANELS




Akiyama Pulsar Front Panel


KEY

Operation

42 MIC INPUT
Connect a Microphone via the 1/4" socket
43 MIC LEVEL
Adjust the Level of the Microphone Input
44 MIC ON/OFF
Turn on/off the Microphone Input
45 TOUCH SENSITIVE
Adjust the Touch sensitivity of the Left and Right Jogwheel
46 XF CURVE
Adjust the slope (curve) of the Crossfader (from Scratch-Cut to Smooth)
47 PFL MIX
Blends audio signals in Headphones Channel between the Master Output (when in maximum-right position) and the Decks that have been selected (with PFL)
48 PFL LEVEL
Adjust the Output Volume of the Headphones Channel
49 HEADPHONES
Connect your Headphones to either the 1/4" or the 1/8" socket



Akiyama Pulsar Rear Panel


50 DC
Optionally use a proper power 6V DC Power Adapter to connect the unit to a power outlet.Note that the unit can operate with USB Power as well
51 POWER
Power on/off switcher. Power on the unit after all other connections are done
52 USB
Connect the unit to a USB port of your computer using the provided USB cable
53 MASTER OUT TRS
Connect your amplifier (speakers) to this balanced Output using TRS 1/8" cables. The level of this output is controlled by the Master knob at the top panel of the unit
54 MASTER OUT RCA
Connect your amplifier (speakers) to this unbalanced Output using standard RCA cables. The level of this output is controlled by the Master knob at the top panel of the unit
55 56 INPUTS
Connect your audio sources to these inputs and can accept both line and phono-level signals.
57 PC/THRU
Use the PC/THRU switcher to send all Inputs directly to the master out (THRU) and mute the software output or to VirtualDJ (PC). See Advanced Setup
59 AUX
CD players, MP3 Player, Tablet Pad and other line level instruments may only be connected to this jack. Input volume will be controlled by the channel fader. The channel INPUT1 (36) selector switch must be in the "AUX".
58 AUX GAIN
Adjust the Output Level of the Auxiiary Input.









Advanced Setup