lynxsound
How can I install/mapp my midi controler as a MIDI Sampler?
I know this could happen in the pro version, sorry for my newbieness (if that's word)
thanks!
I know this could happen in the pro version, sorry for my newbieness (if that's word)
thanks!
Posted Tue 21 Jul 09 @ 11:35 am
SBDJ
You can map the controls to use the sampler using the relevant VDJScript commands. Most of them are prefixed with 'sampler' :)
Posted Tue 21 Jul 09 @ 11:57 am
lynxsound
You can map the controls to use the sampler using the relevant VDJScript commands. Most of them are prefixed with 'sampler' :)
Thanks for your reply and support, but where do I get the VDJScript commands?
Thanks for your reply and support, but where do I get the VDJScript commands?
Posted Tue 21 Jul 09 @ 4:57 pm
jpboggis
Assuming that you are using the v6 trial, a full list of VDJscript commands can be found on the following page: http://www.virtualdj.com/wiki/VDJscript.html
Posted Tue 21 Jul 09 @ 5:31 pm
djdad
It is also very usefull to set your midi controller from the config menu of the VirtualDJ. You may assign an action to your controller by clicking an element on the skin you use. So you don't have to type or learn commands just use the skin you believe is closer to your controller.
Posted Wed 22 Jul 09 @ 10:41 am
lynxsound
I have version 5.7 and my midi controller is a m-audio Oxygen 8. As I said before, I'd like to use it as a controller for my samples and efects.
Posted Thu 23 Jul 09 @ 3:22 pm