yvesmk
In the configuration screen of the time-coded vinyl configuration, there you can see the waveform displaying when you put the needle of your turntable on the TCV.
But how should it look in that display area?
And when do you know your sliders for gain and silence are set correctly?
Any help is much appreciated.
Thanks.
But how should it look in that display area?
And when do you know your sliders for gain and silence are set correctly?
Any help is much appreciated.
Thanks.
Posted Wed 19 Jan 05 @ 9:57 am
PJay
thw waveform shout fill about 75% of the box and the silence is for when you stop the vinyl, you raise the silence untill the grey area covers the line as not to react to background noise.
Also only check the pre amp box if your taking your signal from a phono level out turntable otherwise uncheck it
PJay
Also only check the pre amp box if your taking your signal from a phono level out turntable otherwise uncheck it
PJay
Posted Wed 19 Jan 05 @ 11:01 am
PJay
Also go here as it tells you everything about setting it up
http://www.virtualdj.com/products/timecode/
PJay
http://www.virtualdj.com/products/timecode/
PJay
Posted Wed 19 Jan 05 @ 11:03 am
yvesmk
hey thanks PJay, I was looking for this configuration, recalled seeing it somewhere, but couldn't trace it back.
I was always on the right track, but wanted some confirmation.
I was always on the right track, but wanted some confirmation.
Posted Wed 19 Jan 05 @ 11:59 am