aqus555
Hi when starting VDJ once the controller is already powered up I need to play with some of the buttons in order to reset.
EX. if I put a song in the deck and press play the sound comes from my speakers although the sliders are down. I need to move the slider all the way up and back down in order to reset.
Same thing for the cross fader. I don't like using it so set the controller switch to thru setting but I need to go and slide the slider to left then right then back to thru on all 4 channels in order to deactivate.
Any way around this kind of a pain to do this every time.
Thanks
EX. if I put a song in the deck and press play the sound comes from my speakers although the sliders are down. I need to move the slider all the way up and back down in order to reset.
Same thing for the cross fader. I don't like using it so set the controller switch to thru setting but I need to go and slide the slider to left then right then back to thru on all 4 channels in order to deactivate.
Any way around this kind of a pain to do this every time.
Thanks
Posted Sun 19 Feb 23 @ 11:44 pm
djdad
Windows, right ?
You will need to install the Denon Windows driver for the positions of the faders to be reported on startup.
You will need to install the Denon Windows driver for the positions of the faders to be reported on startup.
Posted Mon 20 Feb 23 @ 4:50 pm
aqus555
Hi yes windows. And I did install the denon drivers for the mc6000MK2 yesterday and makes no difference. Just tried again now
Thanks
Thanks
Posted Mon 20 Feb 23 @ 5:04 pm
djdad
And firmware is updated to the latest version v1003.01 ?
Posted Mon 20 Feb 23 @ 5:25 pm
aqus555
Yes firmware just checked and is the latest
Posted Mon 20 Feb 23 @ 10:59 pm
aqus555
Ok after speaking to tech support I have a partial fix
In Onit I entered the following code: deck all volume 0% & master_volume 0%
that works for the volumes at inital start being set to 0
But can't figure out for the faders how to set it to initail start at Thru instead on switching the 4 switches to reset them.
I think the code is CF_THRU
thanks
In Onit I entered the following code: deck all volume 0% & master_volume 0%
that works for the volumes at inital start being set to 0
But can't figure out for the faders how to set it to initail start at Thru instead on switching the 4 switches to reset them.
I think the code is CF_THRU
thanks
Posted Thu 02 Mar 23 @ 6:42 pm
PhantomDeejay
Also add & deck all cross_assign 'thru'
Posted Fri 03 Mar 23 @ 8:52 pm