Hardware Manuals


Rane - One  

SETUP


Firmware & Drivers


Firmware: There is no firmware update available at the time this manual was written, but it's a good practice to check for updates at Rane DJ Downloads

Drivers: Install the latest drivers (for both Windows and MacOS X computers) from Rane Dj Downloads

VirtualDJ Setup


Download and install VirtualDJ from our Downloads Page (in case you have not done already)

Once VirtualDJ is launched, a Connect Window will appear. Please login with your preferred method from the ones provided.

A Pro Infinity or a Pro Subscription License is required to fully use the Rane One.
Without any of the above Licenses, the controller will operate for 10 minutes each time you restart VirtualDJ.
Buy a license




A detection window will appear next verifying proper connection with Rane One.

Click on the "One" button in order VirtualDJ to apply the pre-defined audio configuration for your device.

Make sure you have the top-panel Source selectors to USB-A or USB-B depending on the USB port you connected at the rear panel.

Click to OK.


The unit is now ready to operate.


MAPPING


The unit should be visible in the MAPPINGS tab of Config and the “factory default” available/selected from the Mappings drop-down list. The factory default Mapping offers the functions described in this Manual, however those can be adjusted to your needs via VDJ Script actions.
Find more details at VDJ Pedia



AUDIO Setup


The unit has a pre-defined Audio setup and a special button in the AUDIO tab of Config to provide that. Alternative Audio setups can be applied in the same window. See Advanced Setup for more details.



For further software settings please refer to the Manuals of VirtualDJ Layout