Hardware Manuals


Pioneer DJ - DDJ-SX2  

ADVANCED SETUP


The Pioneer DDJ-SX2 is offering a built-in sound card which can operate in 2 modes. The default Controller (no-DVS) mode and the DVS Mode. The mode selection can be done via a special DDJSX2 DVS Pad Page. This Pads page will not be available if the DDJ-SX2 is not connected.


DDJSX2 DVS Pads page - DVS On/Off Mode selection


The mode is kept until the next power-cycle. Each time the unit powers on, the default (no-DVS) mode is enabled.

Controller mode (no-DVS)


In this mode the built-in sound card of the DDJ-SX2 offers 2 stereo Outputs which are used to route the Master and the Headphones Channel of VirtualDJ, along with a single stereo Input which is used to record your mix along with AUX/MIC Inputs.
Once the DVS Off Pad is selected, go to VirtualDJ Settings->AUDIO tab and click on the Pioneer DDJ-SX2 special button at the top of the window to auto-create the sound setup for this mode as per the following image.


VirtualDJ Audio Setup with DDJ-SX2 in Controller mode



Timecode (DVS) mode


The alternative (DVS) mode is offering the same stereo Outputs as the default one, along with 2 x stereo Inputs that can be used to connect Timecode CDs or Vinyl In this mode, recording with VirtualDJ will not record the AUX/MIC Inputs.
Once the DVS On Pad is selected, go to VirtualDJ Settings->AUDIO tab and click on the Pioneer DDJ-SX2 DVS special button at the top of the window to auto-create the sound setup for this mode as per the following image.


VirtualDJ Audio Setup with DDJ-SX2 in DVS mode






For further Technical features and specifications, visit

Pioneer DDJ-SX2
Product's Page







Hardware Integration Department
2019 - ATOMIX PRODUCTIONS



Reproduction of this manual in full or in part without written permission from Atomix Productions is prohibited.