Hardware Manuals


Numark - Mixtrack Pro FX - Layout  

DECK CONTROLS




KEY

ACTION

SHIFT (SECONDARY) ACTION

S SHIFT
Press this button down to access secondary actions as described in the SHIFT ACTION column
21 PLAY
Play/pause deck
Plays deck when paused. Jumps to Cue point and continues to play from there when deck is playing (play-stutter)
22 CUE
Sets a temporary Cue point when deck is paused and preview track while pressed.
Jumps and stops to the Cue point when deck is playing
Jumps and stops at the beginning of the track
23 SYNC
Matches track's tempo and pahse with the ones of the Master Deck.
Reset Track's tempo to original value (same as having the Pitch fader to center position
24 JOG
Touch-sensitive jogwheel for scratch, bend, loop adjust.
In Scratch mode (SCRATCH button lit), use the top side of the jogwheel to scratch and the outer side to bend (temporary slow-down/speed-up).

In Bend mode (SCRATCH button unlit), use the jogwheel to bend (temporary slow-down/speed-up)

In Loop In/Out Adjust modes , use the jogwheel to fine-adjust the Loop In (Start) / Loop Out (End) points of a manual loop.
Fast search (seek) through track's time
25 PITCH
Adjust Deck's tempo (BPM)
26 SCRATCH
Toggles between Scratch (Vinyl) and Bend (CD) modes for the Jogwheel
Censor/reverse. Plays track in reverse while held. When released, track will resume from the position it would have been if never played in reverse.
27 PITCH BEND -
Temporary slow-down deck's tempo. Tempo will return to the value designated by the Pitch fader, once the button is released
Select the next available -/+ % range for the Pitch fader
28 PITCH BEND +
Temporary speed-up deck's tempo. Tempo will return to the value designated by the Pitch fader, once the button is released
Enable/disable Key-Lock (Master Tempo). When enabled, the key of the track will retain its value when the Pitch/Tempo is changed.
29 LOOP
Triggers a Loop of the selected size in beats.
Enables the last triggered loop (reloop)
30 LOOP 1/2
Halves the length of the loop.
Set the Entry point of a Loop (Loop-In position). When in loop, sets Jogwheel to Loop-In Adjust mode
31 LOOP x2
Doubles the length of the loop.
Set the Exit point of a Loop (Loop-Out position). When in loop, sets Jogwheel to Loop-Out Adjust mode
Pads