shootdaj
I have several buttons I want to map. One being clone deck 1 to 2, regardless of what the currently active deck is. Then I want to map cloning from deck 2 to 1, 1 to 3, 2 to 3, 3 to 1, and 3 to 2. I know there are commands clone_deck and clone_from_deck, but from what I can tell, these depends on the currently active deck (clone_deck would clone from the currently active deck to whatever deck you specify, and clone_from_deck would clone whatever deck you specify into the currently active deck).
Any have a solution to this?
Any have a solution to this?
Posted Tue 02 May 23 @ 6:26 am
shootdaj
Never mind, I found the solution. Instead of deleting the post, I'm leaving it up in case someone else needs this info in the future:
You use the "deck" modifier to apply the command to a specific deck:
- Clone from 1 to 2 --> deck 1 clone_deck 2
- Clone from 2 to 1 --> deck 2 clone_deck 1
...and so on.
You use the "deck" modifier to apply the command to a specific deck:
- Clone from 1 to 2 --> deck 1 clone_deck 2
- Clone from 2 to 1 --> deck 2 clone_deck 1
...and so on.
Posted Tue 02 May 23 @ 6:39 am
AltRattler
good you left it, thanks!
Posted Mon 22 May 23 @ 12:10 am